discomikey Posted July 12, 2011 Share Posted July 12, 2011 has anyone got a book with the dimensions of the components on the front hub of a coil axle, ie. swivels (both parts), the actual hubs and the shafts that the hub slides onto. any info would be grateley appriciated. Quote Link to comment Share on other sites More sharing options...
discomikey Posted July 12, 2011 Author Share Posted July 12, 2011 can anyone tell me? Quote Link to comment Share on other sites More sharing options...
moore101 Posted July 12, 2011 Share Posted July 12, 2011 What sort of dimensions are you after? It's not very clear from your original post.. Quote Link to comment Share on other sites More sharing options...
Ian Barrett Posted July 13, 2011 Share Posted July 13, 2011 I'll have the front hub of my 1986 Ninety apart today to fit a new swivel. If you want me to measure anything post up details of what you need. Quote Link to comment Share on other sites More sharing options...
discomikey Posted July 13, 2011 Author Share Posted July 13, 2011 the actual swivel overall diameter and the swivel bearing dimensions, also the diameter of the shaft that the hub spins on if possible cheers. Quote Link to comment Share on other sites More sharing options...
Ian Barrett Posted July 13, 2011 Share Posted July 13, 2011 The diameter of the shaft (stub axle?) is 60mm where the seal fits and 45.4mm where the bearing sits. I'll double check them for you though because I took the easy way out and photographed the calipers sitting on the shaft - but the focus is of the rotor so its a bit blurry. I'll get you the diameter of new and old swivel too - to be sure to be sure - as I have the near side one on the floor. I didn't replace the bearing on the near side, so I don't have one to hand yet. Might have it from the offside by the end of the day though. Quote Link to comment Share on other sites More sharing options...
discomikey Posted July 13, 2011 Author Share Posted July 13, 2011 thanks v much Quote Link to comment Share on other sites More sharing options...
Ian Barrett Posted July 13, 2011 Share Posted July 13, 2011 OK, glad I checked The shaft where the seal sits I got correct at 60mm Where the bearing sits is actually 45.3 NOT 45.4 as I quoted earlier The swivel has loads of dimensions. Here are 2 and let me know if you need any others its an odd shape to measure so imagine its a football with 1/3 of it cut off. You can see it will be fatter in the middle than at the edge where it was cut. I have both those sizes Fattest - 133.3 across the cut - 127.8 Quote Link to comment Share on other sites More sharing options...
discomikey Posted July 13, 2011 Author Share Posted July 13, 2011 thankyou for that. reasons will hopefully become apparent soon.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.