Bracket to hold socket for towing electrics

[TheBeastie]

Hi

Towbar electrics fubar and everything corroded shockingly (to be fair it is a lousy place to be down there on a permanent basis!!) so used angle grinder to get the nuts off the bracket that holds the 7 pin socket. Bracket itself not good but the socket I got with bracket attached no use for Defender since hole spacing too wide and holds the socket into the tie bar. Need original where hoe centres are about 60mm and the socket is held above the tie bar.

Looked in the 110 parts manual but cannot find it.

Anyone got any ideas what the number might be so I can get a new one? I suppose I might be able to make one but would prefer proper

Thanks and best wishes

Malcolm

[mickeyw]

Couldn't you use something like this?

You could just use it as intended to position the socket beside the ball, or modify it to use bolted to the side stays.

[western]

got 2 of those on my 110, should be item 8 on page 1059 Accesories section in 110 1987 on parts book,

http://www.retroanaconda.com/landrover/parts_books/110/10_trim_seats_stowage_accessories_p910-1075.pdf

LR part NRC8048

Brt-car http://www.brit-car....php?xProd=88510

LR Series http://www.lrseries....TING-PLATE.html

Famous four http://www.famousfou...p?partID=397191

[TheBeastie]

Thanks Ralph. Never thought of Accessories - tried chassis and electrics.

One lives and learns!!

[western]

only just remembered where I found them in the parts book,