ajh Posted June 1, 2013 Share Posted June 1, 2013 Is there an easy to replace o-ring between the PS line and the banjo bolt on the PS pump? I replaced the two bonded washers but there is still leaking at higher pressures from that area but I'm in a situation where taking it off to check is a bit of a problem as I depend on the same vehicle to go pick up the replacement. Quote Link to comment Share on other sites More sharing options...
western Posted June 1, 2013 Share Posted June 1, 2013 AFAIK the pipe has a bell shaped end to match the dish of the banjo bolt, like brake pipes to caliper fittings, unlkiely if there is a rubber O ring in there Quote Link to comment Share on other sites More sharing options...
ajh Posted June 2, 2013 Author Share Posted June 2, 2013 In that case I likely need to replace the line? any idea on the part number for the LHD version of that one; my catalog doesn't show that variety of steering pump. Quote Link to comment Share on other sites More sharing options...
western Posted June 2, 2013 Share Posted June 2, 2013 looks like my earlier info was wrong, see page 465 onwards http://www.retroanaconda.com/landrover/parts_books/110/5_axles_suspension_steering_p398-471.pdf looks as the banjo end is swaged to the hose not screwed on. I can't find a decent photo of it though, your existing hose should/may have a metal band around it, this is has the part number stamped into it. Quote Link to comment Share on other sites More sharing options...
ajh Posted June 2, 2013 Author Share Posted June 2, 2013 This one is threaded onto the banjo; I guess I'll have to find some time next week to pull it all apart again and check over every fitting to figure out where the leak is happening. Quote Link to comment Share on other sites More sharing options...
western Posted June 2, 2013 Share Posted June 2, 2013 does your look like this one male threaded connection one end & female connection at other end -- NTC6730http://www.british4x4outfitters.com/NTC6730-Defender-25-200TDI-Power-Steering-HosePump-To-Steering-Box-P22794.aspxor this one -- NTC8191http://www.lrseries.com/shop/product/listing/9900/NTC8191-PAS-HOSE.html Quote Link to comment Share on other sites More sharing options...
ajh Posted June 2, 2013 Author Share Posted June 2, 2013 Yes, the same connectors as those. As to which one I'll have to get a look to be sure. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.