Chasman

I'm going to fit this setup to my P38, can you tell me where to get the adaptor loom? And do you happen to have the part number for the DAB module?

Hi Everybody! The U-bolt clamping the front section of my exhaust to the manifold has dissolved to the thickness of fuse wire! I'm going to replace the U, the saddle clamp and the nuts with zinc plated or stainless versions so it will last longer. Is it totally standard 2" or 2.25" or something more peculiar?

Good to know, thank you.

I've just had a pre-owned Ashcroft ATB fitted to the rear axle of my RR P38 4.6... it was a whole, built diff unit, from another vehicle, not a core. Will it need any lash/runout adjustment because it's in a new home?

Cheers!

I'm going to replace the perished main vacuum pipe from my Cruise Control (CC) with some 5mm ID silicone vacuum hose so it never needs doing again. I was going to buy 4-5m does that sound about right? It's a UK right hand drive (RHD) car so the pipe goes right the way across from the throttle actuator along the bulkhead, disappearing into the wiring loom and engine block I can't for the life of me trace where it goes through into the footwell. Any guidance in the form of engine bay "landmarks" or photos would be much appreciated. If anyone has done one of these and there are any groovy tricks to save time and hassle that would be great... It occurs to me I might attach the new hose to the old one at one end or the other to pull the new hose through as I rip the old one out...