robbo65 Posted April 23, 2011 Share Posted April 23, 2011 Just wondering if anyone has any thoughts on a 94 Disco that has now had 2 transfer case input seals start to leak. Its behind a manual r380. the new seals do about 1000km's and then start leaking. I've had a careful look at the seal running surface on the output shaft of the main box, and it looks fine. Has anyone seen this problem before?Thanks. Quote Link to comment Share on other sites More sharing options...
BogMonster Posted April 24, 2011 Share Posted April 24, 2011 A bit of play in the bearing and an out of balance propshaft might do it - will cause the flange to constantly "wobble" inside the bearing. Quote Link to comment Share on other sites More sharing options...
bear Posted April 24, 2011 Share Posted April 24, 2011 Had a similar thing a few years ago on my old 200tdi. Turned out to be a duff oilseal. Regards Quote Link to comment Share on other sites More sharing options...
robbo65 Posted April 26, 2011 Author Share Posted April 26, 2011 Thanks for the thoughts, I think I might refit my guide studs from the 4bolt method,and slide it back far enough just to throw another seal into it.Keep your fingers crossed!! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.