discomikey Posted October 25, 2011 Share Posted October 25, 2011 took me mates prop off other day to do the ujs on it, all goes well untill as the prop fell in half i went to put it back together, now weve tried loads of times but it just wont go back in without a hammer, wich is no good as it wont do the box or front diff any good. so how come it slid off fine biut wont just slide back on? weve tried turning it 180 etc and still no luck. Quote Link to comment Share on other sites More sharing options...
Landy-Novice Posted October 25, 2011 Share Posted October 25, 2011 this happened to me, i just kept rotating it until it went in. HTH Quote Link to comment Share on other sites More sharing options...
discomikey Posted October 25, 2011 Author Share Posted October 25, 2011 weve tried it haha, gona get some nice sandpaper and take the teflon coating off we think. theres supposed to be some arrows to line it up aparently but they aint there Quote Link to comment Share on other sites More sharing options...
Landy-Novice Posted October 25, 2011 Share Posted October 25, 2011 i never saw the arrows! mine didnt just slide in, took a bit of encouraging but i dont care if it damages it, its already got backlash. it was a shame to put hardy spicer uj's on it tho! Quote Link to comment Share on other sites More sharing options...
DDO173 Posted October 26, 2011 Share Posted October 26, 2011 Dont take the teflon coating off! If you do it will be sloppy and horrible and also wear itself worse at an alarming rate. They need to fully in line and use lots on clean grease and it will go back. Quote Link to comment Share on other sites More sharing options...
fozsug Posted October 26, 2011 Share Posted October 26, 2011 Work youre way round spline by spline they will line up easily .....eventually!!!! Quote Link to comment Share on other sites More sharing options...
discomikey Posted October 28, 2011 Author Share Posted October 28, 2011 done it now, there were some alignment marks on the inside instead off the usual outside arrows. strange. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.