FFR Posted September 28, 2012 Share Posted September 28, 2012 Hi, I recently (2009, time flies) changed from canvas and tail gate to hardtop and safari door. I have been running without bottom seal since. In the meantime, I have been buying what I though was the right set of parts to install a seal... with no success, because I can not figure out how to join these bits togeter. I have this: this: and this: and this is the car ! Any hint and/or proper part numbers is greatly appreciated. Carlos Quote Link to comment Share on other sites More sharing options...
Dads Toy Posted September 28, 2012 Share Posted September 28, 2012 The rubber sits on the floor at the back with the round section against the closed door. The piece in the top pic sits on top of it with the flat section towards the door, the lipped section covers any floor covering. It is then rivetted through the rubber to the floor to secure it. The bit in the second pic - dunno! I'll try and get a picture when I finish my fuel filler installation! Malcolm Quote Link to comment Share on other sites More sharing options...
Dads Toy Posted September 28, 2012 Share Posted September 28, 2012 Here you go Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.