Hi All,
I am after a bit of advice regarding ABS faults!
At work we have a 1997 (p-reg) 300 tdi xs Discovery which the ABS was working fine on but one day while out on a job with a 16ft trailer in tow the ABS light decieded to come on & stay on!
After being cautious during the rest of the journey & returning to the yard it was obvious that the ABS was not working!
After some messing about it was noticed that the stop light were also not working, so after investigation the 4 pin brake light switch turned out to be faulty.
I see looking at the diagram 2 pins do the stop lights & 2 pins go to the ABS unit.
The switch has now been replaced but the light still stays on & no ABS!
From what we can see all the ABS sensors are seated ok!
So does anyone have any ideas on what the fault could be? or since the switch has been replaced does the system need to be reset? & if so is there a way of doing this without going to a main stealer?
Thanks for any help or advice!
Regards,