task Posted November 9, 2011 Share Posted November 9, 2011 I have some electric seats, some seat switches and a Discovery but I don't have the wiring loom or diagram to wire all this together. Does anyone know how these are wired or have a link to a document? Alternatively, does anyone have a loom they'd be willing to sell me? Quote Link to comment Share on other sites More sharing options...
zim Posted November 10, 2011 Share Posted November 10, 2011 Take both wires and push them into the 220v mains plug..... Should work :P :P :P Quote Link to comment Share on other sites More sharing options...
task Posted November 10, 2011 Author Share Posted November 10, 2011 haha, thanks I do have the feeling that this may end up being preferable to the actual wiring! Quote Link to comment Share on other sites More sharing options...
PaulMc Posted November 12, 2011 Share Posted November 12, 2011 I have some electric seats, some seat switches and a Discovery but I don't have the wiring loom or diagram to wire all this together. Does anyone know how these are wired or have a link to a document? Alternatively, does anyone have a loom they'd be willing to sell me? I could only find the Heated Seat circuit diagrams in RAVE for the NAS Discovery, I can't see why it would be any different to a UK vehicle - . . . Quote Link to comment Share on other sites More sharing options...
Range Rover Blues Posted November 12, 2011 Share Posted November 12, 2011 I can help you out a bit, if the switches are the same as on the RRC. they have 2 power supplies to the switch and one earth, each supply then has it's own fuse. If you look at the back of the switch you can work out the piars of contacts for each function and wire them to a motor. One the multiplug there is one wire not connected each side, or should I say one pin not fitted to the plug. I worked it out in 10 minutes. Quote Link to comment Share on other sites More sharing options...
task Posted November 21, 2011 Author Share Posted November 21, 2011 Cheers, I managed to get these fitted over the weekend and wired up OK I scavenged the cable for the passenger side from a old RRC seat I had laying about but the drivers side was afflicted with a memory module so that became a complete re-wire so was handy to know they were the same as the RRC. I also found the diagram on the RAVE CD in case anyone else needs it. Took the opportunity to clean out the Disco and waxoyl it while doing so, now good for a few more years inside. Quote Link to comment Share on other sites More sharing options...
fozsug Posted November 26, 2011 Share Posted November 26, 2011 Glad they worked ok Quote Link to comment Share on other sites More sharing options...
Range Rover Blues Posted November 27, 2011 Share Posted November 27, 2011 Job's a good 'un Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.