Bingy Posted June 1, 2013 Share Posted June 1, 2013 Can someone have a look at there original 3pin durite plug from the sensor and then let me know what wire goes to what pin The connector in the kit is a through connector, but I don't have anything to join it to. I have bought the correct 3 pin durite plug just need the correct wiring configaration Obviosly, the wires are red, yellow, green from the MS board Looking illogically at the plug with the wire clip at the bottom and the back ( where the wires go into the plug). Left is????? Middle is???? Right is?????? Or does the configaration matter Cheers Quote Link to comment Share on other sites More sharing options...
Mr Noisy Posted June 20, 2013 Share Posted June 20, 2013 Config definitely matters, the ms colours are the same as the Lucas colours on nige's wiring diagram! Quote Link to comment Share on other sites More sharing options...
Bingy Posted June 21, 2013 Author Share Posted June 21, 2013 Cheers Sam. Only problem that i have is that the 4.6 plenum. It has a 3 prong socket ( similar to an injector, only 3 prongs- wheras the 3.9 TPS sensor is hard wired in) I have managed to get a 3 prong junior plug to match the 4.6 sensor, but, as there wasnt a plug on the sensor previously, i dont know what configuration the wires go. I have been through yours and Niges build, together with the build CD Nige sent me, but all i can find is the three wires going through a male and a female plug and socket Quote Link to comment Share on other sites More sharing options...
FridgeFreezer Posted June 21, 2013 Share Posted June 21, 2013 Quote Link to comment Share on other sites More sharing options...
Mr Noisy Posted June 23, 2013 Share Posted June 23, 2013 Job done Quote Link to comment Share on other sites More sharing options...
Bingy Posted June 23, 2013 Author Share Posted June 23, 2013 Sorted. Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.