jericho Posted December 12, 2008 Share Posted December 12, 2008 I went to fit a 300tdi axle (complete with radius arms) to my old RR two door chassis this evening,and noticed that the old bushes on the chassis appear to be a different size,both internal and external diameter,from the ones on the arms. The older spec bushes are smaller on both diameters by about 3 mm. Is there more than one size bush? I can assemble the 300arms/300bushes/chassis with a little persuasion,but will this cause any problems if the bushes are too big for the chassis holes? Thanks , Jerry. Quote Link to comment Share on other sites More sharing options...
simonr Posted December 12, 2008 Share Posted December 12, 2008 Common belief says NO - they are all the same size. That's what we thought when we started making X-Joints. However, it appears that there are two different PCD's for the fixing bolts in addition to two different bores. The difference is pretty small and you can modify the smaller size by drilling the holes in the bush out from 10.25mm to 12,5. After market bushes generally have 12.5mm holes which avoids the need for two different sizes. Si Quote Link to comment Share on other sites More sharing options...
jericho Posted December 12, 2008 Author Share Posted December 12, 2008 Forgive me - by 'radius arms' I meant the front suspension arms. I thought the rears were generally called trailing arms. If the rears vary,then its likely the fronts will too. Any definite info? Quote Link to comment Share on other sites More sharing options...
Mark90 Posted December 12, 2008 Share Posted December 12, 2008 Early RR chassis mounts will be imperial and are smaller than the metric mounts on later vehicles. Both the internal and external radius on the early bushes are smaller than the later metric ones. A mate who is fitting 300 type axles with later wide type metric raduis arms front and rear to a comp safari racer based on an old RRC is having to replace the chassis mounts on the front as well as the rear. Quote Link to comment Share on other sites More sharing options...
Daan Posted December 12, 2008 Share Posted December 12, 2008 Yes, the 300 arms have different bushes. You can fit earlyer radius arms with a washer either side of the axle end bush, this is what I did. daan Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.