SteveG Posted June 8, 2006 Share Posted June 8, 2006 Needed to mod the standard exhaust where it exits rear box so that it does get knocked about so much. It sticks out quite a way to clear mud flaps.. While it was in for it's 12K service had Mansfield 4x4 use existing pipework and mod it so it exits straight and is tucked up out of way... Seems to work well in my opinion. Steve Quote Link to comment Share on other sites More sharing options...
white90 Posted June 8, 2006 Share Posted June 8, 2006 Looks great Steve but! I had mine like that and landed on in in Bampton woods the river section it squashed it flat (not suprisingly) I have move it further back again on Version4 v1: standard: v2: v3: v4: just about shows it Quote Link to comment Share on other sites More sharing options...
BogMonster Posted June 8, 2006 Share Posted June 8, 2006 Neat You put the tyres on the wrong way round though Quote Link to comment Share on other sites More sharing options...
SteveG Posted June 8, 2006 Author Share Posted June 8, 2006 You put the tyres on the wrong way round though I went for the black on black versions I'll have to see how it goes Tony, it's mounted on one of those rubber isolators so will move up a bit For 20 quid it will do for now and I'll keep away from the river section at Bampton in July Steve Quote Link to comment Share on other sites More sharing options...
GBMUD Posted June 8, 2006 Share Posted June 8, 2006 I went for the black on black versions I'll have to see how it goes Tony, it's mounted on one of those rubber isolators so will move up a bit For 20 quid it will do for now and I'll keep away from the river section at Bampton in July Steve You remember how the P38 exhausts used to dig in when you rolled back? Looks nice though. Chris Quote Link to comment Share on other sites More sharing options...
Andy Posted June 8, 2006 Share Posted June 8, 2006 that story rings a familiar bell. i got sick of pulling exhausts off my disco when failing hills so i cut the pipe just behind the axle & now have a straight pipe that comes out the rear wing. bit tractor in its noise but it does the job. a mate did his very similar but added a few bends & his sounds stock. Quote Link to comment Share on other sites More sharing options...
BogMonster Posted June 8, 2006 Share Posted June 8, 2006 Take the exhaust manifolds off, bolt them back on upside down and put a foot of 3" straight through pipe from each up through the bonnet. Paint a few flames down the side and bob's yer uncle Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.