ajh Posted October 5, 2010 Share Posted October 5, 2010 When fitting the new pressed steel doors the door seal is on the door, but does not go the full length of the bottom of the door. What other seals are needed to complete the seal, right now I can see through about an inch in each corner of the door bottoms, which allows quite a bit of air in while moving. Quote Link to comment Share on other sites More sharing options...
Maverik Posted October 5, 2010 Share Posted October 5, 2010 I just fitted the sill seals instead. works fine. Quote Link to comment Share on other sites More sharing options...
smokinv8 Posted October 5, 2010 Share Posted October 5, 2010 Having looked on a mates 300tdi before, I noticed that there are supposed to be 2 pieces of foam block that fill those gaps. Im sure an adult will be along soon with a part number for you! Quote Link to comment Share on other sites More sharing options...
western Posted October 5, 2010 Share Posted October 5, 2010 with the seal on bottom of the door you also need 4 x AWR3140, suspect these are self adhesive. Quote Link to comment Share on other sites More sharing options...
ajh Posted October 6, 2010 Author Share Posted October 6, 2010 Thanks, that doesn't seem very inspired, I also ended up with a spare set of P seals about 25cm long, any idea where those go? They could be strays picked up at the paint shop as well. Quote Link to comment Share on other sites More sharing options...
western Posted October 6, 2010 Share Posted October 6, 2010 shorter seals are for rear side doors. Quote Link to comment Share on other sites More sharing options...
ajh Posted October 6, 2010 Author Share Posted October 6, 2010 In addition to the V-seal that's already on the door bottom? The holes in the P-seal didn't line up to anything I could find. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.