Mac0972 Posted November 22, 2013 Share Posted November 22, 2013 Turns out i have bought a set of range rover 16 inch alloys for my 1998 90 defender, guess what they dont fit, can i get them to fit or am i wasting my time Quote Link to comment Share on other sites More sharing options...
western Posted November 22, 2013 Share Posted November 22, 2013 the later RR stud centres pattern is closer together, you can fit the wheels if you use adaptors made to fit your existing hubs & the RR wheels, they are out there in land rover & interweb land Quote Link to comment Share on other sites More sharing options...
Mo Murphy Posted November 22, 2013 Share Posted November 22, 2013 Look on Simmonites website for adapters. Mo Quote Link to comment Share on other sites More sharing options...
Snagger Posted November 22, 2013 Share Posted November 22, 2013 I'm assuming that you got the correct generation of RR wheels, ie. RR Classic. However, they won't fit the hubs anyway because the the hub protrudes too far - it wasn't util the introduction of the 300Tdi that Defender axles were fitted with slimmer hubs and flanges that permitted the use of LR alloys. You need to have the inside of the wheels machined out on a lathe to remove a bit of the taper of the void which fouls the bevel on the hubs between the drive flange bolt lugs - if you clean up the wheels and hubs properly and then put some copper grease on the hubs close to the flange gasket and then try fitting the wheel, the grease will be transfered to the wheel where it is in contact. Alternatively, 1/4" spacers work, but don't go thicker than that or the nuts won't have enough thread to engage safely. Even then, I'd be wary - I used such spacer on my 109's rear axle (using front hubs from an early 110" for disc brake conversion), but I replaced the studs with the 1/2" longer Wolf studs (which then required the threads in the nuts to be cut further into the blind end of the nuts' insides as the thread ran out before the nuts closed up on the wheels). You will be left with the plastic hub cones protruding through the wheel centres unless you get creative (my shafts had slightly worn outer splines, so I had the flanges welded on, allowing the cone to be discarded as the weld sealed the oil in the hubs). Quote Link to comment Share on other sites More sharing options...
Mo Murphy Posted November 22, 2013 Share Posted November 22, 2013 ^^^^^^ er 1998 Defender Snagger Mo Quote Link to comment Share on other sites More sharing options...
Snagger Posted November 22, 2013 Share Posted November 22, 2013 Ah, misread as 1988. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.