Bumble Posted September 19, 2006 Share Posted September 19, 2006 Have been looking at buying an S reg Freelander I noticed that there was water in the boot storage box in the boot floor obviously it had been leaking for a long time judging by the amount of mould that was on the boot mat, is this a common fault? Quote Link to comment Share on other sites More sharing options...
white90 Posted September 19, 2006 Share Posted September 19, 2006 yes door seals and condensation from rubber boot mats more info in the tech archive Quote Link to comment Share on other sites More sharing options...
BogMonster Posted September 19, 2006 Share Posted September 19, 2006 Mainly the door seal on the back door; the whole door/complicated seal design with its stupid electric latch and stupider electric window which freezes shut was an abortion waiting to go wrong from day 1 and whoever designed it should be shot! Just my 2p you understand Oh and the other way you can get water in the boot is to reconnect the battery, forget that this makes the window go down and then park it outside in the P*ssn rain for a week. Don't bother asking how I know THAT Quote Link to comment Share on other sites More sharing options...
Blippie Posted September 20, 2006 Share Posted September 20, 2006 Two ways you can get water in the boot. First is condensation, usually on the lid, but will spread mould along the carpet if it is left lone enough. Cure is to air it out and may be drill one or two holes in the lid. Job done. Second is a leaking door seal. More common on older models as a different part number was used later. This leads to significant amounts of water in the cubby after rain. I have this on one of mine. I regularly mop out but will have to bite the bullet and get around to fitting the later door seal at some point. I gather it is a bit of a pain of a job, probably the reason why many haven't been done by the dealers on recall. Cheers Blippie Quote Link to comment Share on other sites More sharing options...
Andy Posted September 24, 2006 Share Posted September 24, 2006 Oh and the other way you can get water in the boot is to reconnect the battery, forget that this makes the window go down and then park it outside in the P*ssn rain for a week. Don't bother asking how I know THAT how do you know that? Quote Link to comment Share on other sites More sharing options...
jules Posted September 29, 2006 Share Posted September 29, 2006 I drilled a 5mm hole in the boot floor sorry Blippie Most early ones sufferd with this but some the dealer sorted in there early days. It strated from the fixings from the gutter above the back window a bead of mastic normaly sorted that out stopped it from sloshing around. Quote Link to comment Share on other sites More sharing options...
Blippie Posted September 29, 2006 Share Posted September 29, 2006 We keep frogs in ours. Cheers Blippie Quote Link to comment Share on other sites More sharing options...
Andy Posted October 2, 2006 Share Posted October 2, 2006 do you need to feed the frogs often? or have you fitted trained LR Spiders to catch them a food supply? Quote Link to comment Share on other sites More sharing options...
Blippie Posted October 3, 2006 Share Posted October 3, 2006 That's a thought ... We each have a pair of "mirror spiders" that cast webs over the wing mirrors but hide away inside when you are driving. Thing is, I've just swapped the mirrors on the Camel for the later 2001MY folding mirrors. It didn't occur to me that I have removed the mirror spiders. I wonder if they are still inside the old ones. Perhaps I should transplant them too. Cheerio Blippie Quote Link to comment Share on other sites More sharing options...
Andy Posted October 3, 2006 Share Posted October 3, 2006 id swop the spiders to the new mirrors if i was you. when my spider left home (ex kicked him out) my gearbox blew up within a month. new spider fitted & less faults since, its true they hold the car together. Quote Link to comment Share on other sites More sharing options...
Blippie Posted October 5, 2006 Share Posted October 5, 2006 Here spidey spidey spidey ... Quote Link to comment Share on other sites More sharing options...
Earl Fender Posted April 5, 2007 Share Posted April 5, 2007 Check the headlining at the inside top of the door. If it is wet then it's not the door rubber, instead the water is getting in through the screwholes that hold the top outer trim in place. It then just drips down at a fair rate of knots into the cubby hole where it becomes a stagnent paddling pool. You will need to remove the outer side trims then the top trim. Unscrew the metal bracket that the top trim clips onto then get some mastic and bed the nylon clips into the holes in the body using the mastic. Run a line of mastic across the top of the screw clips the width of the vehicle (well, what would be covered when the metal strip is back in place) and then squirt some more mastic into the screwholes in the nylon clips then screw the metal bracket back in. Refit the outer trim and snip snip - Bob's yer aunty. You will probably end up breaking the plastic clips that hold the trim on when removing the trim so you best to buy 6 clips for the side trims (each is held on with 3 clips) and 5 of a different type for the top trim before you start. For info, the part numbers are: Side trim clips = DCE 100560 Top trim clips = DYC 101470 Hope this helps. 1 Quote Link to comment Share on other sites More sharing options...
LandieInOman Posted April 5, 2007 Share Posted April 5, 2007 This brings back memorys of our 03 plate Freelander, we had both water in the cubby box and mirror spiders - I also fondly remember the windscreen wipers packing up on wet drive from Aberdeen to Glasgow . The water in the cubby was due to condesation, enhanced by the rubber floor mat. The spiders, we had to pay Land Rover extra for. I solved the water problem by moving to Oman and buying a 1985 110. Needless to say owning an early 110, water is th least of my worries. Stiil looking for Spider accesories though. Quote Link to comment Share on other sites More sharing options...
Blippie Posted May 1, 2007 Share Posted May 1, 2007 The spiders, we had to pay Land Rover extra for. Ah, well, I never know whether to specify pattern, OEM or Genuine Part spiders. Cheers Blippie Quote Link to comment Share on other sites More sharing options...
robkeen1 Posted July 4, 2016 Share Posted July 4, 2016 Hi, I've recently found this youtube clip, which might hold a new insight into the cause of wet boots. the water seems to be coming in from around the tool box holder to boot floor spot welds, I haven't checked it myself yet but a tube of sealant or heavy under body paint might be in order Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.