Jump to content

V8 R380 vs 300TDi R380


Recommended Posts

The clutch splines on the TDi are longer though so not too much of an issue?

I've bolted a R380 V8 bellhousing onto my R380TDi box and the shaft sticks out more or less the same amount as the V8 LT77 i have (~10mm)

A few chaps on here have bored out a V8 spigot bush to take the tdi shaft and it works ok. You end up with a very thin wall thickness, <1mm, which might make it tricky to fit, but it does work.

Link to comment
Share on other sites

I have used both 3.5 R380 and 300 TDI R380 with my 200 TDI engine. in what was a 1999 V8 110.

I got away with using the V8 R380 for 2 years despite the shorter splines until they finaly ripped out miles from anywere while off road, luckily I had an aframe to drag it back to the road and as weather was good (dry) my discovery recovered it no bother.

I have attached a couple of pics showing both versions of the box fitted with a 300 TDI Defender bell housing, they show the diffrence pretty clearly.post-3233-126955580569_thumb.jpgpost-3233-126955587299_thumb.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...

Important Information

We use cookies to ensure you get the best experience. By using our website you agree to our Cookie Policy