666 george

I'll be banging on the gate at 9. Always been a good show for the last 4 years I've been

I used the TD pipes just cut off the flange and add to the down pipe everbody is useing. But I've been told you can use all the Tdi pipe work(not the down pipe). Mine is on it's way out so I'm going to cut up a disco exhaust and make it fit the 90.

Not far from me. Did it about a month ago and it was bone dry (small puddles). I met up with some of the the boys from landyzone this morning a they did it today, don't know what it was like.

The other is 5/8 UNF (15.87mm)

All i did was put a plate between it. It feels like it spins up a bit easyer and more responsive

I had mine changed over at pirtek, had a different size thread

Is a Disco engine in a TD ?

A 3ft long bit of metal !

I took the casting off the disco and changed it with the defender one ! Easy !

Got mine out with heat and a hammer ! To get it back in it took 10 tons in a press.

Just done mine. 3 days all in, with me helping £380 ! Best money i have spent, it runs alot better. I should have done it a long time ago, it would have saved me sh*t loads on diesel.

Try heating it up. I got mine out with a hammer and a blow torch. A friend of mine took it to work to press it back in and it took 10 tons.

Yes the RRC wheels will fit, i had some on mine but they looked a bit to bling for mine. I have a disco back end so couldn't tell you but i think they will be the same as the front, with the centre cap sticking out. They are a bit of a close fit. Think they are 16", you will have more side wall on them. Wobble wobble Graham

The bloke over the road from me gets office rubber backed ones, just cut to the shape you want. Take them out and hang on the line and they are cheap FREE !

My wife was not happy to start with, kept taking the mickey out of me. I wave to all older landy's, but not the new ones(not real land rover driver's).