That was quick. Pretty much what I found. Wasn't sure how critical it was on getting the GND and +5v the wrong way round and releasing smoke.
Thanks for the help I will investigate further.
Adrian
I've converted the inlet on my 5litre to D2 bosch system, everything else has swapped over ok now, except the TPS.
Does anybody know which pin is 5V in, Earth, and the signal output. Rave isn't clear which is which.
Thanks
Adrian
I've fitted the later style V8 coils, as found on D2 and late P38's, does anybody know which pins feed which pair of leads. ie. does pin 1 feed the top 2 leads or vice versa?
I've searched rave and it only seems to give the 3 wires to each coil and is not lead specific.
Any help would be gratefully received.
Adrian
I can supply Mach 5 weld on beadlocks, you don't need to cut off the old rim bead and the finished article looks just like a factory Mach 5 beadlock.
And they are cheaper than £50 a wheel.
Adrian
You need to know the piston diameter and the piston rod diameter to be able to work out the surface area, I would be surprised if the piston rod is the same diameter as the piston, if it was it would only be able to extend, as there is no surface to apply pressure to too retract it.
The olives are part number NRC9771 should be available from your local parts supplier. I think they are 8mm so a plumbers merchant may also be able to supply them.
Hope that helps
Adrian