chris2010 Posted January 3, 2016 Share Posted January 3, 2016 hi can any body give me dimentions on the position of td5 engine mounts. and pics of possible as need to weld these in place . many thanks Quote Link to comment Share on other sites More sharing options...
Maverik Posted January 3, 2016 Share Posted January 3, 2016 You're probably best just mounting the engine to the transmission and measuring and working out yourself the best position... Quote Link to comment Share on other sites More sharing options...
Anderzander Posted January 3, 2016 Share Posted January 3, 2016 I agree with Maverick - seems a lot could go wrong working from measurements on a Land Rover? Quote Link to comment Share on other sites More sharing options...
Bowie69 Posted January 3, 2016 Share Posted January 3, 2016 Yep, mount the gearbox up with the engine attached, mark, remove, weld, refit. Done Quote Link to comment Share on other sites More sharing options...
Aragorn Posted January 3, 2016 Share Posted January 3, 2016 I did mine from measurements, and they're not quite in the right place, there is tension on the gearbox mounts as the engines perhaps 5-10mm too far forwards. I'm going to have to oval the holes in the chassis to let the gearbox mounts slide forward a little, to remove the tension from them. I would get some measurements to work from, but as folk said above, get the transmission mounted up and make sure they all work with your truck, rather than just using measurements alone! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.