renault4 Posted December 26, 2010 Share Posted December 26, 2010 do you grease a CV joint when re-assembling? or does it bathe in axle oil? Quote Link to comment Share on other sites More sharing options...
western Posted December 26, 2010 Share Posted December 26, 2010 There is a CV grease & using it during assembly will ensure there is no excess wear the first time it moves.it also needs the one shot grease or EP90 oil in the swivel housing once fully installed on the axle. Quote Link to comment Share on other sites More sharing options...
LandyManLuke Posted December 26, 2010 Share Posted December 26, 2010 do you grease a CV joint when re-assembling? or does it bathe in axle oil? Yes, I normally put a bit of one-shot around the balls and manipulate it in. What the CV bathes in depends on what you put in your swivels. You do need to either - Fill the swivel with one-shot grease - Fill the swivel with EP90 Additionally, those running EP90 sometimes decide to remove the seal so that oil flows freely between the swivel and axle tube. I personally don't think this is a great idea. Quote Link to comment Share on other sites More sharing options...
Maverik Posted December 26, 2010 Share Posted December 26, 2010 I packed my new CV's with lithium greese prior to installation, then put my one shot greese in also. they're both lithium based so figured it wouldn't do any harm. Quote Link to comment Share on other sites More sharing options...
landroversforever Posted December 27, 2010 Share Posted December 27, 2010 I run oil in mine (with all seals intact). I just assembled dry, poured in the oil and gave them a spin by hand to get the lubed up Quote Link to comment Share on other sites More sharing options...
JimAttrill Posted December 27, 2010 Share Posted December 27, 2010 I am still using EP90, though every time I check the front diff oil it seems to be overfull and I suppose that extra comes from the swivels. At the rear I have deliberately stuffed up the seals by pulling the half shafts in and out a few times so that the EP90 oils the wheel bearings (as in a Series LR). Quote Link to comment Share on other sites More sharing options...
renault4 Posted December 30, 2010 Author Share Posted December 30, 2010 thanks peeps, CV grease it is then. Quote Link to comment Share on other sites More sharing options...
smokinv8 Posted December 30, 2010 Share Posted December 30, 2010 Yes, I normally put a bit of one-shot around the balls and manipulate it in. Quote Link to comment Share on other sites More sharing options...
LandyManLuke Posted December 30, 2010 Share Posted December 30, 2010 I was waiting for someone to pick that up. Quote Link to comment Share on other sites More sharing options...
smokinv8 Posted December 30, 2010 Share Posted December 30, 2010 Quite the topic at the moment, as a female member of my staff has just asked a customer in my shop who was purchasing some peanuts and fat balls "Would you like me to carry your balls to the car for you?" The customer nearly collapsed with laughter and said maybe she should refraise that. Poor love, she didnt have a clue what she'd said! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.