nickm

did the servo connect to your pedal easy enough ? i'm thinking of fitting a rangy servo in replace of my series servo looks very similar to the disco one

me too, never had a prob with them, but i do get things delivered to work (london) so the delivery service may be better than being out in the sticks

has anyone else had to fit a supressor for some reason i get a buzzing noise if i plug in the external spkr

noticed paddocks do the bar think it was £65 cant you just turn the glass upside down on the lights to get rid off the glare on the bonnett ?

mmm must do that bit one day

Maplins do a few found the £50 midland (i think) to be very good

so without shooting myself in the foot why would my 300 disco be ok

been thinking about putting one on the rear of my hybrid apparently very reliable but not as quick as others

there ok but really slow usually quite cheap now

I remember when vic rolled at Llanfylin he went end over end then 2 or 3 rolls but was ok afterwards

depends on the size off tyres n offset axles are the same width as a 90 have a look at a 90 without the arches on n that should give you a rough idea

might be worth checking the price for the 7mtr IMS round this way charge the same for a whole length as they would for an off cut robbing g1ts

mmm i was also thinking about the clutch always works ok tho does seem to mainly do it after its been standing for a while already binned all of the heat shields will check the front radius arms and the alternator sure the only thing that could hit is the pipe to the intercooler cheers

has anyone had a jingle'ing noise that sounds astho you have a chain dragging along the floor ? sounds astho its from the front end or the bellhousing (maunual 200tdi rangey runninggear)

Recently replaced my v5 n arf with a 200tdi bought a complete disco and so had everything that was needed as said above you will need to weld new mounts to the chassis think paddocks sell the actual mounts but i just cut mine off of the disco chassis also never got round to wireing up the cold start but have never needed it and always starts on the button Nick.. not sure if it makes much different but think the insurance companys prefer it if you keep it to a rover lump

hows about these remember u will need 2 of them http://cgi.ebay.co.uk/GENUINE-ANDERSON-SB-...1QQcmdZViewItem

that be the red white n blue 1 any pics of his old disco (after the roll)

might actually get round to doing mine now then

just checking are the rrc with abs stub (swivel bolts) the same pattern as a 24 spline one ? i know the earlier axles are a different pattern and have less bolts

put it into reverse then screw it in that way u wont go too far

anyone know where and cost to get extended rangy brake hoses approx 4 inch longer cheers

theres a hole on the under side of a dizzy to let moisture out (also lets water in) u could run a breather to it i'v seen them being fed into the snorkel so that any moisture is sucked out

Morning would anyone have an awt extended cab soft top fitted to a series landy need to know how far back the cab goes (from bottum of the screen back towards the rear of the mota) cheers for any info

aslong as its not structural it should be ok how can they fail sommit if it aint there ?

cheers mate will look out for a normal 1 i've had to extend the bulkhead end of my bonnett so should have enough room Nick..