monkie Posted May 9, 2021 Author Share Posted May 9, 2021 I think with good planning, you can eliminate a lot of them in most cars I've seen. I think they are mostly for the convenience of the manufacturers. My point is that I chose to use mainly econoseal and superseal on my rebuild and they were not cheap. I fitted connectors where LR had. I think you can easily loose the connectors to the engine harness and chassis harness. In my experience the superseal connectors aren't great with thicker 17amp wires even when using the wider rubber seals. Quote Link to comment Share on other sites More sharing options...
FridgeFreezer Posted May 9, 2021 Share Posted May 9, 2021 Yeah you can wire a lot of stuff direct if you accept that certain maintenance/repairs means cutting the loom which is partly why manufacturers put connectors in - factory assembly being the other. Quote Link to comment Share on other sites More sharing options...
Sigi_H Posted May 10, 2021 Share Posted May 10, 2021 I.e. at the wings and lights just leave the cables in a small loop a little bit longer. That's the place, where you can cut them if necessary. A lot of the connectors i didn't need to separate in 35 years til restoration 1 Quote Link to comment Share on other sites More sharing options...
Anderzander Posted August 29, 2021 Share Posted August 29, 2021 Does anyone know where I could get some of the clips/mounts for superseal connectors ? I’ve started fitting them and in a couple of places it would be nice to not have the connector loose. Quote Link to comment Share on other sites More sharing options...
landroversforever Posted August 29, 2021 Share Posted August 29, 2021 I haven’t looked, but have your tried Durite? Quote Link to comment Share on other sites More sharing options...
PaulMc Posted August 29, 2021 Share Posted August 29, 2021 6 hours ago, Anderzander said: Does anyone know where I could get some of the clips/mounts for superseal connectors ? I’ve started fitting them and in a couple of places it would be nice to not have the connector loose. 3waycomponents sell them on ebay, here - High Quality Superseal Mounting Panel Clip For Use With AMP Superseal 1.5 Series Quote Link to comment Share on other sites More sharing options...
Anderzander Posted August 30, 2021 Share Posted August 30, 2021 Thank you ! Quote Link to comment Share on other sites More sharing options...
oneandtwo Posted August 30, 2021 Share Posted August 30, 2021 22 hours ago, PaulMc said: 3waycomponents sell them on ebay, here - High Quality Superseal Mounting Panel Clip For Use With AMP Superseal 1.5 Series Paul, unrelated but can you make me the adaptor loom from bulkhead wiring loom to chassis loom to enable the rear speakers on my Puma? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.